| From | Message |
Luke
Dodge Dakota
JOIN HERE
8/27/2003
20:45:15
|
 Subject: Door Inserts
IP: Logged
Message:
Does anyone have a good way to remove the door inserts and put them back in? The seem to be melted in place, and I can remove them to reupholster them, but can I get them back it right? Thanx
|
ian
Dodge Dakota
JOIN HERE
8/27/2003
23:51:00
|  RE: Door Inserts
IP: Logged
Message:
Just drill the melted part out, being carefull to not go through (basically drill off the "head")
After you reupholster them put the pieces back in and epoxy where the posts used to be melted.
|
Luke
Dodge Dakota
JOIN HERE
8/28/2003
13:33:42
| RE: Door Inserts
IP: Logged
Message:
Thanx dude...that's kinda what I was thinking, but a second opinion makes me feel better about it.
|
stony22
R/T
9/06/2003
15:02:29
| RE: Door Inserts
IP: Logged
Message:
I just used a soldering iron and melted the tabs as i pulled them out. to put it back on try the same method to melt it back together. if not use epoxy. good luck. not too hard though
22's
|
DrewzR/T
Dodge Dakota
JOIN HERE
9/06/2003
15:23:24
| RE: Door Inserts
IP: Logged
Message:
Yeah i used my dremel to sand the head off then I used the epoxy like they said.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
