From | Message |
91DakotaFreak Dodge Dakota JOIN HERE ![Email](http://www.dodgedakota.net/amb/icons/email.gif)
12/10/2002 13:31:27
|
Subject: Intake sizes????? IP: Logged
Message: I am trying to change my intake on my 91 kota it has the tbi 318 with the stock tb on it I do have a 5.2L tb that I ran during the summer. What i want to know is if the itake off of a tbi 360 would fit the 318. If it does will there be any port overlap or anything? I am wanting to do this to get rid of the overlap where the tb bolts to to remove the hesitation and smooth out the airflow. THanks for the help
|
91DakotaFreak Dodge Dakota JOIN HERE ![Email](http://www.dodgedakota.net/amb/icons/email.gif)
12/11/2002 22:08:54
| RE: Intake sizes????? IP: Logged
Message: Please Help????????????
|
POWER HUNGRY Dodge Dakota JOIN HERE
12/11/2002 22:58:10
| RE: Intake sizes????? IP: Logged
Message: Your talking about intake manifold right?
It should bolt on since the block dimensions are the same. I don't think there is much if any diference between the 360 and 318 manifold. If you talking about the overlap of the tbi venturis and the plenuem opening, why don't you grind it to match? The hesitation probably has more to do with the ignition/sensors. If I were going to change the manifold I would be looking at how hard it would be to put a edelbrock rpm airgap manifold on. Would most likely only have to add some holes to mount any sensors..
|
91DakotaFreak Dodge Dakota JOIN HERE ![Email](http://www.dodgedakota.net/amb/icons/email.gif)
12/12/2002 17:28:22
| RE: Intake sizes????? IP: Logged
Message: i would grind it but its like a .5" dia difference. what is the part # for the intake manifold from edlebrock. The hessitation i should have described more what i ment to say was the restriction the air has to by pass
|
POWER HUNGRY Dodge Dakota JOIN HERE
12/12/2002 22:48:51
| RE: Intake sizes????? IP: Logged
Message: http://www.truckperformance.com has the description and info on all edelbrock manifolds for pre-magnum 318/360(performer,performer rpm, performer rpm air-gap). It also say the motor it has to have 340/360 heads? There is also the Weiand action plus dual plane that say it fit the stock heads, basicly the same.
|
| P 1 |
|
Post a reply to this message:
Username Registration: Optional All visitors are allowed to post messages
|