Forums
Forum Tools
|
 |
00:38:10 - 12/20/2024
General Dakota Board
| From | Message |
GlenC
GenIII
 
11/30/2002
21:07:53
|
 Subject: Speedometer Stuck on 120
IP: Logged
Message:
So my drivers side headlight went out today, and to change it, i have to remove the battery, the bumper, my filter, and the intake 'tube' for my supercharger. Dont get me started on how much fun all of that is just to change a single bulb...
But anyways, i had the battery out for at least 15 mins or more, and so the computer reset. No biggy right? Well, after i got everything back to gether, i started the truck and let it idle and such. Then i shut it off and went inside. About 30 mins later, i had to go move the truck so someone else could get out of the driveway, and when i got in and started the truck, the speedo was stuck on 120. It actually looks like its resting on the pin. When i turn the truck off it doesnt go back to zero, it just stays at 120+. I figured it had something to do with the computer, so i reset it by unplugging the neg. battery cable, and put the key to the start posistion for 30 seconds (probably did like 60). The problem is still there. No matter what i do it just seems to be stuck. I hope i dont have to pull the dash apart and pull the needle of and reposistion it. I dont know why i would have to do this, but im wondering if that would fix it. I do have different gauges, and this is the first time the battery has been removed sence i put them on. I figured i'd post here and go get some dinner. Im out of ideas, so any advice would be greatly appreciated. Thanks a million.
GlenC
'01, CC, SLT, 4.7, Auto, 3.55 LS, 4x4
MBRP cat back. JBA Headers. Kenne Bell supercharged.
My Truck
|
DakotaDan
*GenIII*
11/30/2002
22:07:02
|  RE: Speedometer Stuck on 120
IP: Logged
Message:
Try this
1. Ignition switch off
2. Press and hold the trip reset knob
3. Turn the ignition switch to on but do not start.
4. Hold the reset knob for approx 10 seconds
the dash panel will go through a self check
Be ready to write down any codes that show up on the read out
Dan
Next Time You Think You're Perfect
~~~~~Try Walking On Water~~~~~
|
DakotaDan
*GenIII*
11/30/2002
22:14:40
| RE: Speedometer Stuck on 120
IP: Logged
Message:
Glenn
This might explain it better.
How can I recalibrate my instrument cluster?
Dan
Next Time You Think You're Perfect
~~~~~Try Walking On Water~~~~~
|
xplikt
GenIII
12/01/2002
00:01:17
| RE: Speedometer Stuck on 120
IP: Logged
Message:
hahaha, weird. No help from me, but it's funny.
-Mike
http://www.dodgetruckworld.com/xplikt/
2002 2WD RC SLT 4.7L 5spd 3.92 LSD
MBRP Single in/out, straight piped 3rd cat, turndown tip
Hotchkis swaybars and springs
Bilstein custom tuned shocks
Roadmaster Active Suspension
Shaved emblems and antennae
|
GlenC
GenIII
12/01/2002
02:11:59
| RE: Speedometer Stuck on 120
IP: Logged
Message:
That did it dan, thanks! I figured the restting of the computer would work, but that didnt do a damn thing. But, when i had it run the tests it fixed it self when it did the speedo test.
And you.... xplikt... pffffff what do you 2wd kids know anyways. :P
Just kidding. :)
GlenC
'01, CC, SLT, 4.7, Auto, 3.55 LS, 4x4
MBRP cat back. JBA Headers. Kenne Bell supercharged.
My Truck
|
Alvin Simmons
Dodge Dakota
JOIN HERE
4/03/2018
00:36:32
| RE: Speedometer Stuck on 120
IP: Logged
Message:
Hey thanks man I had that problem read
your response went outside did what
you said and everything is back to
normal thanks again
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
|
