Forums
Forum Tools
|
 |
00:41:01 - 12/20/2024
General Dakota Board
| From | Message |
QwikKota
Dodge Dakota
JOIN HERE
10/14/2002
12:08:47
|
 Subject: 4.7L 3" Exhaust Job? Parts Required??
IP: Logged
Message:
Hey all. I have amassed a bit of parts for doing a 3" single out on my 2002 4.7L 5spd CC. I need to know what all I should have to give to the muffler shop to have welded up. Here is what I have so far.
3" Carsound Hi-Flo Cat Conv.
3" Borla Center in/Offset out Muffler
3" Cutout with weld on flanges
3" In/3.5" Out Slant Tip
I would prefer to have a flanged connection from the y pipe to the cat but I need to know what to buy. Do I need a 2.5" to 3" flanged header collector or what? I know some of you out there have this setup on your trucks and I need to know what else is left to purchase. Also I think I need a weld in O2 bung on there in front of the cat?? Do most places keep any mandrel bent tubing in their stock? I think the only bend will be going out of the truck before the tip, like a 45* elbow. Thanks guys!
qwikkota@yahoo.com
Grady C.
|
QwikKota
Dodge Dakota
JOIN HERE
10/15/2002
09:09:15
|  RE: 4.7L 3
IP: Logged
Message:
Anyone???
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
|
