| From | Message |
LMAO
Dodge Dakota
JOIN HERE
12/16/2009
16:37:24
|
 Subject: RE: Band adjustments
IP: Logged
Message:
"someware" ??????
Is that like housewares?
|
MJ
Dodge Dakota
JOIN HERE
12/16/2009
19:52:25
|  RE: Band adjustments
IP: Logged
Message:
I DUN DAT ON PERPUSS....
|
dewayne
Dodge Dakota
JOIN HERE
11/27/2010
21:43:51
| RE: Band adjustments 42rh
IP: Logged
Message:
what is the front and rear band adjustments for a 94-42rh, exactly stock specs?
|
dewayne
Dodge Dakota
JOIN HERE
11/27/2010
21:46:45
| RE: Band adjustments
IP: Logged
Message:
come on man wtf
|
daddio
Dodge Dakota
JOIN HERE
11/28/2010
08:37:54
| RE: Band adjustments
IP: Logged
Message:
"come on man wtf"
Evidently you have not read this thread from the start. If this doesn't do it for you, you can purchase a service manual at the parts store.
Stubbs
Dodge Dakota
JOIN HERE
12/05/2003
18:56:57
RE: Band adjustments
IP: Logged
Message:
ADJUSTMENT - BANDS
FRONT BAND
The front (kickdown) band adjusting screw is located on the left side of the transmission case above the manual valve and throttle valve levers.
Raise vehicle.
Loosen band adjusting screw locknut. Then back locknut off 3-5 turns. Be sure adjusting screw turns freely in case. Apply lubricant to screw threads if necessary.
Tighten band adjusting screw to 8 N�m (72 in. lbs.) torque with Inch Pound Torque Wrench C-3380-A, a 3-in. extension and an appropriate Torx� socket.
Back off front band adjusting screw 2-7/8 turns.
Hold adjuster screw in position and tighten locknut to 41 N�m (30 ft. lbs.) torque.
Lower vehicle.
REAR BAND
The transmission oil pan must be removed for access to the rear band adjusting screw.
Raise vehicle.
Remove transmission oil pan and drain fluid.
Loosen band adjusting screw locknut 5-6 turns. Be sure adjusting screw turns freely in lever.
Tighten adjusting screw to 8 N�m (72 in. lbs.) torque.
Back off adjusting screw 2 turns.
Hold adjusting screw in place and tighten locknut to 34 N�m (25 ft. lbs.) torque.
Position new gasket on oil pan and install pan on transmission. Tighten pan bolts to 13.6 N�m (125 in. lbs.) torque.
Lower vehicle and refill transmission with Mopar� ATF +4, Automatic Transmission fluid.
|
| | <<Original Post <<Previous Page P 2 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
