Dodge Dakota ForumDodge Dakota PhotosDodgeDakota.net Membership
  Forums   Forum Tools
00:48:36 - 12/20/2024

General Dakota Board
FromMessage
Gentleman
Dodge Dakota
JOIN HERE
 Email

5/31/2002
14:37:36

Subject: Aftermarket Alarm Hood Pin Switch
IP: Logged

Message:
To anyone who has installed them, where is the best location, and any problems with rain shorting the pin to ground when the hood is closed.



LoneStarDak
Dodge Dakota
JOIN HERE


5/31/2002
15:15:36

RE: Aftermarket Alarm Hood Pin Switch
IP: Logged

Message:
Gentleman:
I would not use a hood pin switch. i have installed alarms for a few years and pin switches will rust and cause false alarms. If you have remote start they can also disable the starter; not good if your stuck w/o tools. I would suggest getting a mercury switch. Any good alrm distributor shopuld be able to supply these. Also if you have an underhood light i would connect a trigger wire to it instead as it will funtion just as well as a pin switch. Still I prefer to use mercury switches for that type of application. My own vehicles are setup that way and i haven't had any trouble with it. Mers are also perfect for flat lid toppers and tool boxes.




LoneStarDak
Dodge Dakota
JOIN HERE


5/31/2002
15:23:37

RE: Aftermarket Alarm Hood Pin Switch
IP: Logged

Message:
just realized that i did not even answe your question.

anywhere that you can keep the pin from rusting will be fine. if you have the clearance try covering the bottom side of the pin with a cap of some sort and seal it to the body panal w/ silicone to keep the moisture out . Also try to find a small rubber boot for the top of the switch to keep moisture out. That's about all i could suggest if you want to use the pin switch. Any location will work fine that allows the oine to be grounded and make good contact w/ the hood. Just my $.02



Gentleman
Dodge Dakota
JOIN HERE
 Email

5/31/2002
15:47:27

RE: Aftermarket Alarm Hood Pin Switch
IP: Logged

Message:
Thanks for the mercury switch idea and the underhood light idea, I think I will go with the underhood light since it already has a mercury switch built in, I was skeptical of the pin switch for the reasons you stated, thanks again for your time and ideas, greatly appreciated.



   P 1


Post a reply to this message:

Username Registration: Optional
All visitors are allowed to post messages


Name:
Email:
Notify me when I get a reply to my message:Yes  No

Icons:            

          

Subject:
Message:
 



Home | Forums | Members | Pictures | Contact Us

This site is in no way affiliated with Chrysler or any of its subsidiaries.