| From | Message |
Bluethunder
Dodge Dakota
JOIN HERE
5/21/2002
10:44:12
|
 Subject: Neon tube installation
IP: Logged
Message:
I just bought a few 10" neon tubes for under the seats. How can I wire them to a switch? They come with plugs for the lighter. I assume I find a 12v power source...run that to the switch then tie twist the 2 lights together and run that to the switch? Make sense? Any help would be appreciated
|
R_U_FST2
Dodge Dakota
JOIN HERE
5/21/2002
11:50:59
| RE: Neon tube installation
IP: Logged
Message:
Not sure if you are going to get much help from this crowd ... those products tend to be in the realm of the ricer, sworn enemy of the Dak. LOL.
|
Urhistory
Dodge Dakota
JOIN HERE
5/21/2002
12:26:35
| RE: Neon tube installation
IP: Logged
Message:
run a 12 volt power source to a switch, then cut off lighter end and take positive wires of lights and run to switch, and find a screw to ground the negative wires to. I have 6 neons insides and a few outside.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
