| From | Message |
DakSXT
Dodge Dakota
JOIN HERE
4/30/2002
17:57:01
|
 Subject: Non-foglight bumper info needed
IP: Logged
Message:
Hey all,
My SXT has the front bumper with the foglights holes NOT punched/pressed/knocked out.
I would like to open these holes if possible without damaging the paint.
Has anyone attempted to this and if so what is the best way to go about it and with what cutting tools ???
Thanks
John L Rivait
2002 Dakota SXT CC Patriot Blue
|
Bill
Dodge Dakota
JOIN HERE
4/30/2002
19:34:52
|  RE: Non-foglight bumper info needed
IP: Logged
Message:
I am not sure what you mean by what you said about the bumper. If yours is like my 2001 CC, then it has the parts in the bumper that look like a fog light goes there, but the plastic hasn't been cut, but you can kind of see where the hole should go. If that's how yours is, then it is probably a 4" hole like mine. I used a 4" hole saw on a drill and then cleaned up the edged with a Dremel with a sandpaper type attachment. I didn't really have to worry about paint since my bumper is just gray plastic. YOu can kind of see what mine look like on my website.
SOrry if this was confusing!
Bill
Bill's Truck Page
|
Ryan
Dodge Dakota
JOIN HERE
4/30/2002
19:47:23
| RE: Non-foglight bumper info needed
IP: Logged
Message:
I also have a 2002 SXT with those ugly cheap looking plastic wanna be fog light depresions. I also want to get fog lights installed and I'm wondering what brand is best? Anyone have any opinions? How good are the one Dodge sells?>
Ryan
|
Bill
Dodge Dakota
JOIN HERE
4/30/2002
19:49:13
| RE: Non-foglight bumper info needed
IP: Logged
Message:
I have a set of Pilot fogs. They are good and they really weren't expensive, less than $50 i believe (they were a gift). I have been very pleased with them so far.
Bill
Bill's Truck Page
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
