From | Message |
Bill Dodge Dakota JOIN HERE
3/04/2002 08:08:50
|
Subject: Wet Okole Pics? IP: Logged
Message: I was thinking of getting a set of Wet Okole seat covers for my 2001 3.9 4x4 CC with the dual buckets. I was also thinking about getting some custom Door inserts. Do they make them? Does anyone have pics of the seat cover or the door inserts? Thanks.
Bill
http://members.aol.com/btaylor04/BTruck.html
|
Dakota GenIII
3/04/2002 11:04:56
| RE: Wet Okole Pics? IP: Logged
Message: Check out Chuck's site...
Http://www.intense99dak.com
The photos are here: http://www.intense99dak.com/picsint.htm
Might have to navigate through his site to get to it as it is set up in frames version.
-Dakota 3" Body Lift Quick D Intake Dynomax Race Magnum Exhaust Http://dakota.4mg.com
|
BlackDak02 *GenIII*
3/04/2002 14:57:20
| RE: Wet Okole Pics? IP: Logged
Message: Bill,
I saw that you have a black CC also. I have the black/grey Okoles on my front bucket seats. Sent you a few pics.
2002 Black CC SLT 4x4 4.7L 45RFE 3.55 LSRD
|
Bill Dodge Dakota JOIN HERE
3/04/2002 15:15:59
| RE: Wet Okole Pics? IP: Logged
Message: Got your e-mail John. Thanks a lot!
Bill
http://members.aol.com/btaylor04/BTruck.html
|
Bluethunder Dodge Dakota JOIN HERE
3/04/2002 16:11:54
| RE: Wet Okole Pics? IP: Logged
Message: http://photos.yahoo.com/bc/sreal22/vwp?.dir=/Dodge+Dakota&.src=ph&.dnm=wet+okoles+1.jpg&.view=t&.done=http%3a//photos.yahoo.com/bc/sreal22/lst%3f%26.dir=/Dodge%2bDakota%26.src=ph%26.view=t
|
Bill Dodge Dakota JOIN HERE
3/04/2002 16:31:46
| RE: Wet Okole Pics? IP: Logged
Message: Thanks for those pics bluethunder. I am really starting to think about these!
Bill
http://members.aol.com/btaylor04/BTruck.html
|
Marks DQC GenIII
3/04/2002 21:55:27
| RE: Wet Okole Pics? IP: Logged
Message: I did the door panel inserts myself. Wet okole does not make them. I love the seat covers!
2001 Dakota Quad Cab SLT , 4.7L, Auto, 3.55 LSD, Garnet Red over Slate Zaino, Tint, Vent Guard, Gaylords Lid, Hotchkis Springs, Bilstein Shocks, Wet Okole Covers, Painted Grill Shell with Ram inserts, S/S Bumper/Valence Cover, Billet Antenna, Precision Roll Pan, APC Clear Corners, Airaid Intake
|
Bluethunder Dodge Dakota JOIN HERE
3/05/2002 08:35:23
| RE: Wet Okole Pics? IP: Logged
Message: How did u do that Mark? Does the door material just rull off? Then just cut and glue the neprene on? Can you tuck in the edges for a clean look?
|
Marks DQC GenIII
3/05/2002 10:57:44
| RE: Wet Okole Pics? IP: Logged
Message: The procedure is quite involved. How I replaced the door panel inserts on the Dakota:
1. Remove whole door panel. The inserts are held on by 8 plastic welds.
2. Grind out the plastic welds with a dremel.
3. Remove the fabric covering the plastic panel. This was very time consuming and tough on the fingers, the fabric is glued on and will eventually peel off. I pulled and used a putty knife most of the time.
4. On the small panel a short (1/2-3/4 in.) plastic tube will remain. I drilled through these and then on the face I countersunk for a machine screw.
5. Then I took a 1-1/2 in. no. 8 machine screw, inserted through the hole and used JB weld to epoxy it in place. Eight of these for each panel.
6. On the main panel, with a dremel, I ground any left over flashing around the old plastic welds until they were level and flush.
7. After the epoxy set on the small panel, I made sure there were no lumps by sanding each of the screw heads.
8. Then I put double sided tape over the whole face and around the back side edges.
9. I stretched the new material over the panel and around the edges. I securely taped down the edges on the back side.
10. Then I placed the screws in the small panel into the main panel and used a fender washer, lock washer, drop of locktight, and a nut to bolt them on.
11. I put the panel back on and voila!
2001 Dakota Quad Cab SLT , 4.7L, Auto, 3.55 LSD, Garnet Red over Slate Zaino, Tint, Vent Guard, Gaylords Lid, Hotchkis Springs, Bilstein Shocks, Wet Okole Covers, Painted Grill Shell with Ram inserts, S/S Bumper/Valence Cover, Billet Antenna, Precision Roll Pan, APC Clear Corners, Airaid Intake
|
| P 1 |
|
Post a reply to this message:
Username Registration: Optional All visitors are allowed to post messages
|