Dodge Dakota ForumDodge Dakota PhotosDodgeDakota.net Membership
  Forums   Forum Tools
01:04:25 - 12/20/2024

General Dakota Board
FromMessage
moe-z
Dodge Dakota


12/17/2001
18:22:03

Subject: dak seems sluggish, engine light on
IP: Logged

Message:
over the weekend the check engine light came on, and now it seems really sluggish, no acceleration down low at all. I checked other engine light posts, also tried the code thing but nothing came up, the engine light was the only thing and it just stayed on

I will check more tomorrow, but just wondering if anyone has any ideas. I have a homebrew intake, but that has been on since august.

Should I look into buying a scan tool, or does anyone in Toronto have one I could borrow??

Thanks in advance,

Brad
'98 CC 3.9 2wd



Simpleman96
Dodge Dakota
 Email

12/18/2001
11:08:24

RE: dak seems sluggish, engine light on
IP: Logged

Message:
Check the fuel pressure at the rail. May be the fuel pump. Mine did the same thing but did not give me a code. The (check eng) light just came on and it barely runs now. Hope it is not the problem they are expensive.



Jacob
Dodge Dakota
 Email

12/18/2001
13:11:59

RE: dak seems sluggish, engine light on
IP: Logged

Message:
Yout catalitic converter is bad...famous for happening in the 3.9L, if you are still under warrenty take it in and tell them to replace it



moe-z
Dodge Dakota


12/18/2001
13:22:34

RE: dak seems sluggish, engine light on
IP: Logged

Message:
thanks for the help

I will bring it in, problem is I bought it used and the 6 month/10 000 km warranty ends on the 27 of Dec and I am 300 km over the 10 k, maybe they will help out or something.

Brad



moe-z
Dodge Dakota


12/18/2001
19:22:22

RE: dak seems sluggish, engine light on
IP: Logged

Message:
Well I went for sort of a long drive, after a while it seemed the power was back, but light still on. Then the power was back for sure, but it wouldn't go into 3rd (auto).

I was planning on taking to the dealer and thought I would put back in the stock airbox, started it and the light was off. took it for a spin and the light stayed off and it ran normally, shifted and everything. I didn't reset the PCM though, so thats not why the light went out.

ANy ideas what is going on? The intake has been on for almost 5 months, now its acting funny. Have I solved the problem or is this just learning the new intake?

I kind of thought maybe it is running too lean, with the intake and the cold air of winter, but its not that cold in Toronto, I don't know.

Brad



   P 1


Post a reply to this message:

Username Registration: Optional
All visitors are allowed to post messages


Name:
Email:
Notify me when I get a reply to my message:Yes  No

Icons:            

Subject:
Message:
 



Home | Forums | Members | Pictures | Contact Us

This site is in no way affiliated with Chrysler or any of its subsidiaries.