| From | Message |
Curtis
Dodge Dakota
12/09/2001
21:59:57
|
 Subject: wiring a brake control
IP: Logged
Message:
Anyone out there can help me like to pick your brain! I have a 2002 dak. 2x2 4.7 auto WITHOUT Factory tow package. I have installed the brake controller, ran the power, ground and the brake (blue) wires to where they go. My question is I have to tap into the NONE power side of the brake switch (under the dash) and I don't know which wire is it? there are 6 wires coming out of the brake switch. Which wire is it? What color code is it? I know if I tap into the wrong wire I mess up my ABS brakes!!
Anyone????????
Thanks Curtis in AZ
|
Jeff
Dodge Dakota
12/09/2001
22:28:24
|  RE: wiring a brake control
IP: Logged
Message:
Even though you don't have the factory tow package, you should have the plug under the dash to directly plug in a brake controller without any wiring hassles. It should be above the clutch pedal(if so equipped or in that area) with a baby blue plug with I think 4 wires going into it. It will have a termination plug in it that you just remove and plug in your controller, takes about 5 minutes max
|
Jon
Dodge Dakota
12/10/2001
16:11:07
| RE: wiring a brake control
IP: Logged
Message:
I wouldn't worry about towing with your truck. You have bigger problems such as the fact that your truck only has two wheels! How does it stay balanced?
|
dj
Dodge Dakota
12/10/2001
16:14:58
| RE: wiring a brake control
IP: Logged
Message:
Jon, that was funny!! I laughed out loud!!
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
