| From | Message |
BlueBayou
Dodge Dakota
11/09/2001
23:05:43
|
 Subject: Fault Code P0700
IP: Logged
Message:
Cold evening (38 degrees) and I had to give it quite a bit of gas to get out in traffic. Truck was not warm at the time. Truck sputtered then ran fine.
Didn't seem like a tranny issue.
Any insight?
Do I have to go to the dealer?
Thanks
Blue
|
bernd
*GenIII*
11/10/2001
01:04:43
|  RE: Fault Code P0700
IP: Logged
Message:
My P-Codes database only goes up to 1999.
However, the 700 series are all related to the transmission. Here's the generic definition of the P0700 code:
Chrysler/Dodge/Plymouth P0700 "EATX or Aisin transmission controller has an active fault and has requested MIL
1997 Dodge Dakota SLT - V6
Supercharged @ 10# w/Nitrous
|
Dan Gruber
Gen III
11/11/2001
09:27:54
| RE: Fault Code P0700
IP: Logged
Message:
Here's what my service manual says:
EATX Controller DTC Present
This SBEC III or JTEC DTC indicates that the EATX or Aisin controller has an active fault and has illuminated the MIL via a CCD (EATX) or SCI (Aisin) message. The spscific fault must be acquired from the EATX via CCD or from the Aisin via ISO-9141.
Here's what I know: MIL=malfunction indicator light; DTC=diganostic trouble code; CCD=Chrysler collision detection. Beyond that, I'm clueless. Sounds like it needs to be read out at the dealer. Then again, if it was a one-time glitch, it might clear itself after several drive cycles.
Dan
2000 CC SLT 4.7 4X4 Auto 3.55 LSD
|
jj
Dodge Dakota
11/11/2001
19:52:54
|  RE: Fault Code P0700
IP: Logged
Message:
http://www.obdii.com/codes.asp
|
jj
Dodge Dakota
11/11/2001
19:55:14
| RE: Fault Code P0700
IP: Logged
Message:
Manufacturer DTC DTC Title
Chrysler/Dodge/Plymouth P0700 "EATX or Aisin transmission controller has an active fault and has requested MIL
|
BlueBayou
Dodge Dakota
11/12/2001
09:48:37
| RE: Fault Code P0700
IP: Logged
Message:
Thanks Guys! I appreciate the help.
For furture information, I the next day I took her our to warm up the tranny fluid so I could check it. Drove about 15 miles, checked the fluid.... it was low.
Now, I'm a little pissed. Dealers had it in a couple of times for general maintance, and she doesn't leak fluid!
After checking the fluid the light went out, without add any fluid. Hmmmm????
Oh well, in to the dealer she goes! I need the rotors turned anyway.
Again, Thanks for the help
Blue
|
BlueBayou
Dodge Dakota
11/13/2001
16:59:59
| RE: Fault Code P0700
IP: Logged
Message:
Going to pick up the Truck tonight.
Dealer stated that all sensors are reading correctly and the error code is not telling them which sensor requested the MIL. Oh well... just a fluke.
He did state that Dodge is coming out with a new shift program for the 45RFE in a couple of months thought.
|
Dan Gruber
Gen III
11/13/2001
21:26:54
| RE: Fault Code P0700
IP: Logged
Message:
My dealer mentioned a revised shift program as well, although he didn't say when it would be available. The one he told me about would raise the minimum speed at which the converter can lock up in overdrive by about 8 mph...in my case that means 50 mph rather than 42. I wouldn't mind that at all...I don't like the converter locking up so early. I do a lot of driving between 40 and 45, so my converter is constantly locking and unlocking. It doesn't drive me insane or anything, just annoys me to the point that I'll lock out OD until I hit 50 or so.
Dan
2000 CC SLT 4.7 4X4 Auto 3.55 LSD
|
Izzy
Dodge Dakota
JOIN HERE
10/03/2007
18:05:16
| RE: Fault Code P0700
IP: Logged
Message:
DOn't mean to drag up an old post but thats exactly what I am doing.
My truck JUST started acting strange. My tranny is nailing the gears...cool huh? Only problem is that it is because of a P0700 code and the truck is kinda bogged down speedwise also. I limped it home (right past Marty from KRC's house) to look further into the code.
I realize its a transmission code relating to a controller having an active fault but can anyone further clarify this?
No recent work done on transmission, no puddle or even drips in my driveway, fluid appears to be within the right levels.
Thanks up front for any info.
Izzy
|
kris
Dodge Dakota
JOIN HERE
10/04/2007
13:11:39
| RE: Fault Code P0700
IP: Logged
Message:
I got this code while I was driving down the highway to VA. It seemed like the truck lost overdrive. When I was at a complete stop, the truck bogs down and the RPMs wind out until the truck decides to shift. I took the truck to a nearby dealership and they said that the transmission fuid was low. They filled it up, and it fixed the problem. BTW, I have a 01 QC 4.7
|
Izzy
Dodge Dakota
JOIN HERE
10/04/2007
13:30:09
| RE: Fault Code P0700
IP: Logged
Message:
Fluid was the first thing I checked, thanks Kris for the reply/suggestion though.
|
QQQ
Dodge Dakota
JOIN HERE
10/06/2007
07:59:20
| RE: Fault Code P0700
IP: Logged
Message:
PO700 is a kind of generic code. I had it once. (2000 4.7 auto). I brought mine to autozone to have the codes read. (PO700 will show using the key on/off, but there are other codes that wont show up using the key on/off.) PO700 is like a master code, other failures will cause the code to be thrown, but the code for the original failure will be stored in the computer and can only be read with a code reader. Bring it to autozone or someplace that reads codes and it'll tell you the code that caused the PO700 code to be thrown.
|
izzy
Dodge Dakota
JOIN HERE
10/08/2007
12:58:11
| RE: Fault Code P0700
IP: Logged
Message:
Ended up being a $47 sensor that mounted down near the transmissions somewhere. Total price out the door of the stealership was $197.10 and less than 30 minutes. Got charged 1.5 hrs of labor because thats was the "time & materials" charge is for that item.
|
Orhan
Dodge Dakota
JOIN HERE
7/14/2008
17:07:19
|  RE: Fault Code P0700
IP: Logged
Message:
Which $47 sensor is it? mounted down near the transmissions, For P0700 code I already pent $860 at the dealer (famous Dodge dealer for 2002 intrepid) and the engine light is still on. Could you please tell me the name of the piece at least.
Thanks
|
trina
Dodge Dakota
JOIN HERE
7/17/2008
18:36:05
| RE: Fault Code P0700
IP: Logged
Message:
i just got the p0700 code on my car, i have a dodge intrepid 01. I brought my car to my mechanic and he said it read Electronic automatic transaxle diagnostic. Which he said meant that in the near future my shifts won't work. I called the dealership and they told me that 0700 send different codes out. So it all depends on what it reads
|
JR Doorslamer
Dodge Dakota
JOIN HERE
10/13/2008
22:29:52
| RE: Fault Code P0700
IP: Logged
Message:
2000 Dodge Dakota 4.7 liter started shifting very hard and would not go into overdrive check engin lite came on. Turned key off and on three times and it displayed a P0700 code. I replaced the transmission input shaft sensor and the output shaft sensor. I still have to connect it up to a code scanner to turn of the check engin lite but it is running fine again. If you hook up an ohm meter to the bad sensor of the two, the bad sensor will read open the good sensor will read around 500 ohms. Probably best to replace both sensors as a pair Cost $38.00 each at dodge dealer
|
richard
Dodge Dakota
JOIN HERE
5/10/2009
03:34:20
| aFhikQsfRuqdlaYTz
IP: Logged
Message:
MJy9yH dkv7Rq29nVvzm74lApqSw
|
Breining
Dodge Dakota
JOIN HERE
6/05/2009
13:00:29
| RE: Fault Code P0700
IP: Logged
Message:
2000 Dakota shifts fine when cold revs up before going into OD found trouble was with TPS change that had to do it 2 times got a bad one from action auto . now it is acting up again took to trans place pull codes getting a PO845,868,867,869,not able to ID these codes can any one send me a definition on them checked fluid it was OK i have 98000 mi.mostly all highway i have changed the trans filters 3 times since i got truck 30000 60000, and 85000, bottom line is it still will not shift properly into OD IT will run fine if i take it out of OD ANY ONE GOT ANY IDEAS
AL B
|
Clint
Dodge Dakota
JOIN HERE
7/06/2009
18:53:32
| RE: Fault Code P0700
IP: Logged
Message:
I had the same problem with my wifes Durango. The dealer had it a week or so and when it got back about a day later it came on and my tranny fluid was low filled it and no more problems.
|
endang s
Dodge Dakota
JOIN HERE
7/15/2009
23:59:39
| RE: Fault Code P0700
IP: Logged
Message:
I have a problem in my chrysler grand voyager. The engine is hunting ( back fire )..from the scanner report that there is " P 0700 EATX Ctrller DTC Present " ...what that i have done is :
1. clean the intake and combustion chamber
2. replace the catalyc converter
3. replace the MAP sensor..
and what should i do next ? the problem still there..
thank you for you help
|
Sarezynz
Dodge Dakota
JOIN HERE
11/05/2009
16:08:51
| RFXXwnMfKpCXoUDdQ
IP: Logged
Message:
comment5
|
| | P 1 Next Page>> |
