Forums
Forum Tools
|
 |
01:05:15 - 12/20/2024
General Dakota Board
| From | Message |
madmanmax
Dodge Dakota
JOIN HERE
8/18/2016
16:44:54
|
 Subject: gauge cluster fail now no bus error
IP: Logged
Message:
At first all Warning light were always on but
non of my gauges worked. I knew the sensors
were working because I could look at my speedo,
tach, and temp using the obdII port. I found a
9.56v on pins 3 & 11 on the obdII port should
be 2.5v I believe. tracked the problem to the
instrument cluster and replaced it now my
gauges work. however, I now get a no bus error
and all my warning lights are still on. I've
tested 3 & 11 again and get 4.5v now I also
noticed if I lift the emergency brake pedal the
instrument cluster shuts off completely. I have
no trouble codes and the truck runs and drives
like new. Anyone with more experience with
Dakotas have any thoughts on this?
|
madmanmax
Dodge Dakota
JOIN HERE
8/26/2016
16:47:35
| RE: gauge cluster fail now no bus error
IP: Logged
Message:
I located a faulty wire on interment cluster c1
plug (That is the right hand plug behind interment
cluster) pin 4 Z2 20BK/LG GROUND (right column,
2nd pin down, black wire with green stripe)
original cluster also works fine now.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
|
