| From | Message |
Mopar4u
Dodge Dakota
JOIN HERE
11/12/2013
15:14:00
|
 Subject: Ball joint question
IP: Logged
Message:
Doing ball joints for the first time on my 4x4 02 dakota. Quite
the task when everything is rusty.
I put moog joints in. I got my drivers side done and completely
put together. I realize that I didn't press the bottom joint all the
way, it's about 3/16" from being fully pressed in. I think????? I
got the c clip all the way on. This is bothering me. Is there a
safe way to pop the joints apart without destroying the rubber
boot so I can crank on the lower ball joint more?
|
niebs
Dodge Dakota
JOIN HERE
11/13/2013
21:12:52
| RE: Ball joint question
IP: Logged
Message:
well if you did it right and never-seize the crap out of it haha then it shouldn't be terrible. just go slowly and try not to beat it up.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
