Forums
Forum Tools
|
 |
00:20:09 - 12/20/2024
General Dakota Board
| From | Message |
Brandon
Dodge Dakota
JOIN HERE
2/24/2008
22:50:20
|
 Subject: Alright heres the deal
IP: Logged
Message:
I was installing my 1.7 harland sharps last night. I dropped one in the sand and now I have to buy a new one. I have to drive the truck so I left one set of the stock rockers on the truck. I don't think the different rocker combination will harm anything but I wanted to ask first. Do you think everything will be alright?
To make matters even worse... the truck wont start anymore. As Larry said earlier, "start the engine and let it run for 1min. Then turn the engine off and let it sit for 10mins. Do this three times and its ready to go". Well the engine started just fine the first two times. When I tried to start it the third time all the engine did was make a clicking noise(starter). I charged up the battery and still nothing. Then replaced the starter with a new one. Still Nothing!!! Tomorrow I am going remove the Superchips program and then try to turn the engine by hand. I figure this will tell me if something is stuck. Otherwise I have no clue...any ideas?
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
|
