| From | Message |
joevit
Dodge Dakota
JOIN HERE
8/22/2007
08:42:27
|
 Subject: Outer Tie Rod Ends
IP: Logged
Message:
Can anyone tell me how many turns to put on tie rod ends to start. I'm thinking it was 18 but can't remember. I wrote it down when I took them off but can't find it anywhere. 00 dak V6 4WD.
thanks
|
joevit
Dodge Dakota
JOIN HERE
8/24/2007
09:13:37
| RE: Outer Tie Rod Ends
IP: Logged
Message:
help
|
Eddie
Dodge Dakota
JOIN HERE
8/24/2007
16:29:24
| RE: Outer Tie Rod Ends
IP: Logged
Message:
There is not a set number of turns
Its different from truck to truck
You'll just have too put it on the best you can and then go get a front end alignment.
|
ch4ng
Dodge Dakota
JOIN HERE
8/24/2007
17:35:01
| RE: Outer Tie Rod Ends
IP: Logged
Message:
When I did mine it was 18 for the old one. I installed the new one the same number of turns.
But....Eddie is correct you should get and alignment done.
|
pete
Dodge Dakota
JOIN HERE
8/25/2007
12:09:44
|  RE: Outer Tie Rod Ends
IP: Logged
Message:
when you change your tierods ends just back off jam nut or mark where it is backoff jam nut just enough so you can to loosen tierod off put back on back to jam nut location tighten jamnut back and you should be close to where your alignment was and if road test feel if any pull or any issue related if you think your off then i would pay for it to be aligned back to specs.if you didn't have any wear on your tires usually you can follow this guidline i do and haven't had a problem
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
