| From | Message |
Forseti
Dodge Dakota
JOIN HERE
8/18/2007
10:30:48
|
 Subject: Window problems
IP: Logged
Message:
The drivers power window seems to be getting stuck by the window seals ....when i roll it up it shakes real bad like some how the window seals are not letting it go up smoothly ... the felt part that touches the window seems fine and i can figure out how to solve this problem
|
Jimmy9190
Dodge Dakota
JOIN HERE
8/19/2007
01:39:12
|  RE: Window problems
IP: Logged
Message:
That sounds like a bad window regulator or power window motor. Or the regulator assembly might just be loose in the door. Remove the door panel and check that it is bolted in tightly and there are no obstructions in the widow track and that the regulator assembly is not binding anywhere. One way to check the regulator is to operate the window switch and smack the motor with a hammer-not too hard-If the window works the motor is shot and the motor/regulator assembly has to be replaced as a single unit.
Hope this helps. Let us know how it turns out.
Jimmy
|
Forseti
Dodge Dakota
JOIN HERE
8/19/2007
10:45:20
| RE: Window problems
IP: Logged
Message:
Window works fine when the door panel is off..... only has problems when both window seals are in contact with the window.... if i wet the seals the window will open fine .... its almost like the felt on the seals are somehow sticking to the window but the felt seems fine ........ maybe i just need to buy new seals or somehow lube them....
|
Stevepacman
Dodge Dakota
JOIN HERE
8/31/2007
16:01:49
|  RE: Window problems
IP: Logged
Message:
Had a similar problem with my R/T driver's side window. Worked fine when it got wet in the rain too. Was considering replacing the motor/regulator and all track seals, but when I had the door panel off the last time, I sprayed everything (uppper & lower seals, track hardware) with a silicone spray. That was a year ago. So far, so good.
|
KR
Dodge Dakota
JOIN HERE
7/18/2011
16:37:13
| RE: Drivers side Window problems
IP: Logged
Message:
The drivers power window will go up with the track seals but half way down the window comes out of the track seals. Window is difficult to push back down to realign in the track seals. Do I need to replace the track seals?
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
