| From | Message |
Midnightdak
Dodge Dakota
JOIN HERE
1/17/2007
20:37:26
|
 Subject: Need help on Ford 9 inch
IP: Logged
Message:
I want to get a Ford 9 inch installed in my 2001 dakota but I can't run the same wheels. I need help on what I could do to the front to maybe get the same bolt pattern as the ford 9. I need to mini tub the dakota and want to run the same wheels. Money is no big deal i have alot of money in this ride and need to hook-up.
|
DSW
Dodge Dakota
JOIN HERE
1/18/2007
00:42:25
| RE: Need help on Ford 9 inch
IP: Logged
Message:
Look up Currie Enterprises down in Southern California, I had them narrow a rearend for me years back. From what I remember they can match your front bolt pattern, but it could cost some bucks.
|
Midnightdak
Dodge Dakota
JOIN HERE
1/18/2007
19:08:23
| RE: Need help on Ford 9 inch
IP: Logged
Message:
Thanks alot but i am on the east coast. If i can't get it done over here i'll look them up though because i got buddies on the west coast. I may just have to take a vacation. :)
|
Kowalski
GenIII
1/19/2007
07:52:48
| RE: Need help on Ford 9 inch
IP: Logged
Message:
I believe Moser engineering is another company that will put custom bolt patterns on your rear axle shafts to match what you have in front. Shouldn't need to be close to these places, just tell them what you need and they'll make it for you.
Lead, follow, or get out of the way
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
