mikesz
*GenIII*
 
10/30/2006
16:14:18
|
 Subject: Home brew air intake
IP: Logged
Message:
Planning to install cold air intake kit,but im still in doubt if it makes sense.So,today I came to decision to make temporary kit.Found flexible alu pipe in building store worth 5 USD.Beside few couplings ,I need the right filter element.Think K&N will be the best.Could You tell me what type of cone filter You use??
Excuse me for stupid question,but I live in "metrical"area(Europe)Found that for intake, 3 inch pipe is being used,but it means 76 milimiters.When I measured diameter of OE pipe,it is almost 100 mm what means close to 4 inch???What is a real diameter in milimeters of a filter and inner diameter of a pipe???
Have another question:as far as I can see,nobody uses heat and sound insulation on kit's pipe.I think it should be helpfull because of temperature and loudness matters.Am I right???
mikesz
mikesz
|
