Dodge Dakota ForumDodge Dakota PhotosDodgeDakota.net Membership
  Forums   Forum Tools
03:20:44 - 12/24/2024

General Dakota Board
FromMessage
larry
Dodge Dakota
 Email

9/09/2001
13:06:31

Subject: heater fan fusable link
IP: Logged

Message:
'92 Dak. Although I've replaced the fan motor, the 50 amp fusable link keeps blowing. The resistor block is intact although one lead looks like it's suffered from some heat, it measures less than an ohm across it. I've been told that the dashboard switch module should be replaced but at $200 (!), I'm wondering if;a) I can clean the switch or, b) look elsewhere for the problem. Thanks a lot, Larry



Demon-Xanth
Dodge Dakota


9/10/2001
10:41:09

RE: heater fan fusable link
IP: Logged

Message:
If a 12V line is running 48A, there is approximately 0.25 ohms of impedance between ground and the 12V supply. Less than an ohm isn't suprising. Often the switches can be cleaned by that isn't usually the cause of shorting.

Under what conditions does the link blow? (immediately? when the fan is on a high setting? Intermittantly?)



   P 1


Post a reply to this message:

Username Registration: Optional
All visitors are allowed to post messages


Name:
Email:
Notify me when I get a reply to my message:Yes  No

Icons:            

Subject:
Message:
 



Home | Forums | Members | Pictures | Contact Us

This site is in no way affiliated with Chrysler or any of its subsidiaries.