Forums
Forum Tools
|
 |
01:17:00 - 12/20/2024
General Dakota Board
| From | Message |
Dan M
Dodge Dakota
JOIN HERE
1/02/2006
17:25:00
|
 Subject: RE: no start, no spark at coil output
IP: Logged
Message:
I called shop I use and they were closed. I called one dealership who was less than helpful, guy was not very friendly. Called another dealer and spoke to a guy who gave me a part # for a wiring repair kit that dodge has. They did not have any in stock and no info available so he could not tell me what it included. He gave me phone # for another dealer that showed up as having kit in stock. Called them and they checked and could not find part. They were not sure what all it contained.
Went out with wife, stopped by a NAPA which was different than the ones I called. Guy there suggeted I use 5 min epoxy. He said it should work fine and is listed for not more than 200 degrees. Regular super glue I have is good for 180 degrees.
And there is no easy way to jumper it past the connector. I will try the epoxy. Takes 5 to set, 15 and you can touch it and 1 hour to totally cure.
Will post a follow up once I get that done.
- Dan M
|
Dan M
Dodge Dakota
JOIN HERE
1/03/2006
03:30:29
| RE: no start, no spark at coil output
IP: Logged
Message:
If it isn't one thing, it's another. The epoxy seems to be holding up well so far.
However on my way to work this morning, my MIL comes on and i get 24 and 52.
TPS voltage out of spec (high or low) and O2 sensor running rich.
- Dan M
|
| | <<Original Post <<Previous Page P 2 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
|
