From | Message |
bobby Dodge Dakota JOIN HERE
10/13/2005 12:46:34
|
Subject: center enclosure IP: Logged
Message: i have recently built a custom enclosure to replace my middle seat and here are the dimensions if anyone is interseted( or can understand them!) what i did is kinda hard to explain with words but ill try.
the box goes up the back wall about 18" then out about4" (at 9 1/2"W)then i angled two pieces on both sides 2 1/4" each to create kind of a trapizoid shape, this gave me 14" to put the 12" speaker in....its at a 45 degree angle....at the bottom of the speaker area (14"x14" square") i continued the angle down to 12"....from there i went straight towards the dash to the 31" mark...at this point i just 45ed it down to the floor under the dash. thats the best way i can explain it till i get pics. the amp is mounted behind the passenger seat. anyone else done this?
i used a 12" pyle elite 2000 watt sub
|
GraphiteDak GenIII
10/13/2005 13:29:08
| RE: center enclosure IP: Logged
Message: Several people in the custom audio section have pics of similar but usually two smaller subs.
2000 watts for one 12", IF that's what it runs, is a sh*t load and un efficient if it draws that kind of power. Damn!
Most higher end subs actually draw like 300 watts.
Anyway. Good job. Pix are always a must on something like that.
|
bobby Dodge Dakota JOIN HERE
10/13/2005 15:09:52
| RE: center enclosure IP: Logged
Message: im just telling u watt it says on the back of the sub....2000watts....its a driver..does that make a difference? im going to try to post pics
|
bobby Dodge Dakota JOIN HERE
10/13/2005 15:15:41
| RE: center enclosure IP: Logged
Message:
this is the exact sub listed on ebay
Item number: 5818475356
Item Specifics - Car Subwoofers
Brand: Pyle RMS Wattage: --
Model: PLW12DRE Voice Coil: Dual
Size: 12 inches Condition: New
Enclosure Included: --
Two Brand New Pyle 4000 Watts (total) Power Super Powered Aluminum die-cast
12" Car Subwoofers~
Retail Price: $409.95 for two
Our Price: $129.95 for two
Features:
Red Aluminum Cone
Red Powder coat insets on Die-Cast Frame
2000 Watt Peak Power
1000 Watt RMS Power
2 X 40 Oz double stacked Magnets
Nominal Impedance: Dual 4 Ohms
Heavy Duty High Power Handling Driver
Wide Butyl Rubber Surround
Aluminum Die-Cast Basket
SPL: 85.0 dB
X-Max (in): 0.4
Qts: 0.539
Qes: 0.601
Qms: 5.205
Ultra Sleek and Modern Design
Dual Stacked Magnet Structure
Chrome Mesh Magnet Vent
2.5'' 4 Layer Dual Voice Coil
Allen Key Connection Terminals
|
bobby Dodge Dakota JOIN HERE
10/17/2005 14:53:29
| RE: center enclosure IP: Logged
Message: i should have probably went the 10" route though...it wouldve made life alot easier
|
| P 1 |
|
Post a reply to this message:
Username Registration: Optional All visitors are allowed to post messages
|