Forums
Forum Tools
|
 |
01:28:22 - 12/20/2024
General Dakota Board
| From | Message |
MadMason
Dodge Dakota
JOIN HERE
8/09/2005
04:06:46
|
 Subject: Custom Trailer Wiring Harness
IP: Logged
Message:
Is it possible to make your own harness? Does anybody have chart wich pin on the rear light connector is for which light?
thx in advance
|
CalDak
Dodge Dakota
JOIN HERE
8/09/2005
09:30:10
| RE: Custom Trailer Wiring Harness
IP: Logged
Message:
You do just as well to save the time and get a plug in harness, modify that to your needs. I took an off the shelf 4pin type and modded it into a 7pin socket (using a groovy vintage Mopar parts socket with a cast in penta star on the cover) for my trailer with brakes.
If your really into it, I suppose you could go at the trucks harness with a test lamp...
|
Kowalski
GenIII
8/09/2005
16:37:17
| RE: Custom Trailer Wiring Harness
IP: Logged
Message:
If you start with a pigtail from an RV supply place, this is fairly simple; many will include a wiring diagram. For a 7 pin set up, here's the common colors/sizes/use:
#1 white, 10 gage, common ground
#2 blue, 12 gage, electric brake
#3 green, 14 gage, tail, liscense, running
#4 black, 10 gage, battery charge
#5 red, 14 gage, stop & left turn
#6 brown, 14 gage, stop & right turn
#7 (center) yellow, 14 gage, extra auxillary circuit
The numbers jump around, once you get the pigtail to start with this should make sense; but if you're confused once you have the pigtail in hand just post again and I'll tell you which pin is which #.
Lead, follow, or get out of the way
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
|
