| From | Message |
Kaderdak
GenIII
 
4/26/2005
20:58:22
|
 Subject: Initial TPS voltage???
IP: Logged
Message:
I was bored this afternoon so I thought I'd look into this "TPS mod" that everyone has been talking about. Did all the necessary reading then decided to go at it. Only problem was, I checked the initial voltage reading from my TPS....it's already at .82v??? I thought factory settings were anywhere from .3-.7. Has anyone else seen an unaltered TPS reading this high on our trucks. If so, why?
BTW....'97 5.2L
** '97 Dakota 5.2L 4x4 w/3.55(my best ebay purchase yet) **
** Homebrew CIA, Dynomax Catback, March Underdrive Pulleys, Transgo Kit **
** Borg Warner Brass Cap/Rotor to Taylor 8mm wires to NGK plugs **
** Homebrew dual electric fan setup with 180* thermostat **
** Sitting on BFG 31 x 10.50's **
** Tons more once I'm not a poor college student :) **
|
Bob Lincoln
Dodge Dakota
JOIN HERE
4/27/2005
13:13:03
|  RE: Initial TPS voltage???
IP: Logged
Message:
I will check mine when the weather clears. The FSM says it must be minimum 0.2 volts with throttle closed, but does not give typical specs. Sounds high for stock. Will post my result.
|
ricardcapecod
Dodge Dakota
JOIN HERE
4/28/2005
08:11:34
| RE: Initial TPS voltage???
IP: Logged
Message:
Kaderdak, if you are at .82v, you have nothing to play with.
Some engines don`t like to be set at more than .75v, but again, .82v is close enough.
Let us know what you did.
Peace.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
