| From | Message |
02dak
Dodge Dakota
JOIN HERE
11/25/2004
12:21:16
|
 Subject: Help! Overhead console question
IP: Logged
Message:
Since i finally have a day off, i thought i would hard mount my XM Tuner. I want to attach it when my "Sunglass Clip" is now. My Question is, How do i get the sunglass Clip out? If I have to remove the overhead console, how do i do that?. Thanks in advance!
|
tom
Dodge Dakota
JOIN HERE
11/25/2004
16:05:30
| RE: Help! Overhead console question
IP: Logged
Message:
there is a screw in the front. remove the screw and it is also held by 2 clips at about the centre. grasp the plastic firmly and pull down
|
davisqc
Dodge Dakota
JOIN HERE
11/25/2004
23:43:39
|  RE: Help! Overhead console question
IP: Logged
Message:
Speaking of overhead console, I am wanting to buy one of the computerized consoles for my dak. They are selling on E-bay for about 100.00. I was wondering if anyone knew if there was a factory wire harness up there that I could plug the unit into, or will it just be more trouble than it is worth. I think they would be more novelty than anything, but I still want one. Oh yea, mine is an 01
|
HSKR
Dodge Dakota
JOIN HERE
11/27/2004
22:26:04
| RE: Help! Overhead console question
IP: Logged
Message:
If you didn't get the overhead computer from the factory, then there is no wire harness up there for it. I have sucessfully installed a overhead computer from my old '99 into my '00. You have to run wires down to the drivers side of the dash board. So if you buy one off Ebay, make sure they will include all the factory wiring from the dash up. You will also need a wire diagram for both the model year it was removed from and one for your truck to make sure you get the wires in the correct spot. Took me about 2 hours to install it and it's been working just fine with all the correct readings.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
