| From | Message |
dave318
Dodge Dakota
JOIN HERE
9/03/2004
00:23:01
|
 Subject: TPS???
IP: Logged
Message:
i have a dakota and it cuts out at 3500rpm its a manual and it seem to be runing real rich im pretty sure its the TPC jus to check i started my truck an unpluged the TPC no change in how it ran are rpm could this be my problem?
|
?
Dodge Dakota
JOIN HERE
9/03/2004
11:18:54
| RE: TPS???
IP: Logged
Message:
More likely = O2 sensor !
What year ? 318/5.2 V8 ?
|
dave318
Dodge Dakota
JOIN HERE
9/03/2004
19:29:50
| RE: TPS???
IP: Logged
Message:
its a 97 318 ant i dont thinks its 02 sebsor cuz the motor cuts out at 3500rpm in every gear so the motor will not rez no more than 3500 and if floor the peddel while driving it will jus load up so keep up the suggestion guys
|
Bob Lincoln
Dodge Dakota
JOIN HERE
9/03/2004
22:37:05
| RE: TPS???
IP: Logged
Message:
Check TPS voltage at closed and at wide open throttle. Turn ignition ON (not start) and probe with a voltmeter from center wire to ground. Minimum voltage at closed throttle is 0.2 volts, according to service manual. At wide open throttle, less than 4.0 volts. Typical numbers for stock setup would be closer to 0.4 volts at closed throttle, 3.8 volts at WOT. Also, sweep the throttle through its range and voltage should increase smoothly. Or check resistance with key off with an analog multimeter, so you can watch the meter's needle sweep smoothly. If there are glitches, replace TPS.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
