| From | Message |
Jeff
Dodge Dakota
JOIN HERE
4/17/2004
14:19:33
|
 Subject: help! can't get pcv out!!
IP: Logged
Message:
Help! in the middle of my first diy tune-up, and i can't get the pcv out!
i disconnected the hose, and the little bugger spins, but wont pop out!
what to do??
jeff
ps - its all oily inside, the hose too.
|
Jeff
Dodge Dakota
JOIN HERE
4/17/2004
15:12:34
| RE: help! can't get pcv out!!
IP: Logged
Message:
come on! i know someone knows!
its a '99 3.9, with a blue pcv that wont pull out!
i can always use excessive force to pull it out if necessary, but dont know if thats a good idea, or necessary.
|
.boB
Dodge Dakota
JOIN HERE
4/17/2004
15:28:47
| RE: help! can't get pcv out!!
IP: Logged
Message:
It is a press fit, no fancy fastners or adhesives. Spray a little PB Blaster in there, and pull it straight out. Make sure to pull straight out, not at an angle. If you break it off, you'll have to pull the valve cover to get it out.
|
what?
Dodge Dakota
JOIN HERE
4/17/2004
15:35:53
| RE: help! can't get pcv out!!
IP: Logged
Message:
man up and pull that thing out the worst that happens is the
rubber grommet in the valve cover comes out with it, so what
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
