Forums
Forum Tools
|
 |
01:18:08 - 12/20/2024
General Dakota Board
| From | Message |
Wil Hannes
Dodge Dakota
JOIN HERE
1/25/2004
18:26:54
|
 Subject: 04 Noise in cab
IP: Logged
Message:
I have a new 04 club cab with a strange problem. Some smart engineer decided the heater/A/c system would work better if there was 2 vents in the back of the cab to allow airflow. The only problem is that while allowing nice airflow, it also lets in all kind of road noise, exhaust sounds, etc. It sounds the same as riding with 1 of the rear side windows open. My 99 club cab did not have these vents and was 100% quieter.I tried to remove the rear seatback to tape over or cover these vents, but I cannot get the back cushion to release. Anybody know how to remove the seatback, please let me know. Thanks
|
Matt
Dodge Dakota
JOIN HERE
1/25/2004
18:50:03
| RE: 04 Noise in cab
IP: Logged
Message:
There are four bolts which must be removed to take the backs off of the seats. They are located one on each side of the seat and they go through the hinge assembly then into the seat back. The ones towards the outside of the vehicle are under a plastic cover. If I remember right, the bolts are a T45. After these are removed, then lift up on the seat back and it should slide right out of it's brackets. Hope this helps!
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
|
