From | Message |
samtheman Dodge Dakota JOIN HERE
1/16/2004 05:04:03
|
Subject: Prefer gaskets! IP: Logged
Message: Anyone know where I might get gaskets for my 03, 4x4 differentials? I don't like working with permatex. I have a hollow punch set to make them if I have to.
|
Rob454 Dodge Dakota JOIN HERE
1/16/2004 11:52:50
| RE: Prefer gaskets! IP: Logged
Message: Actually permatex isnt bad at all to tell you the truth. anyway I know most automotive stores carry sheets of gasket material to make your own gaskets. Ive purchased them by the roll and by the sheet.
heres a tip for you on punching the holes. I go shooting a lot. I took some of the spent cases from ammo and they have a sharp open end. I have a few different sizes for different holes. they make a sharp edged hole when you use a small hammer to punch the holes. Most gun ranges will give you a couple.
the nice thing is a small wire will clean out the leftover paper circle inside the case.
Hope this helps you a little. I was looking for gaskets myself and they said nobody makes them Dodge recommends gasket goop for the seal.
ROb
|
EBL Dodge Dakota JOIN HERE
1/16/2004 12:41:25
| RE: Prefer gaskets! IP: Logged
Message: Repeat: Spent cases
Each time I see this bit of advise offered, I think of some person shooting themself. You can't save people from themself, but it doesn't hurt to remind.
|
| P 1 |
|
Post a reply to this message:
Username Registration: Optional All visitors are allowed to post messages
|