| From | Message |
Tyler
Dodge Dakota
JOIN HERE
11/23/2003
23:45:44
|
 Subject: DVC Questions Please!!
IP: Logged
Message:
Hi!
I have recently bought 2 Power Base 12" Subs for my 99' Reg. Cab S-10. The amp I got was a Boss 600w 2 channel amp. What would be the best, (if any), way i could bridge the 2? Please send the reply via e-mail, because I can get to it quicker! Thanks alot!
Tyler
|
Stubbs
Dodge Dakota
JOIN HERE
11/24/2003
19:47:46
|  RE: DVC Questions Please!!
IP: Logged
Message:
Is the amp bridgable, What ohm are the subs, what is the power capacity of the subs (RMS and Peak watts)?
Need more info.
|
BadMoFo
Dodge Dakota
JOIN HERE
11/24/2003
19:55:29
|  RE: DVC Questions Please!!
IP: Logged
Message:
What you wanna do is run the tape out to the power amp, then that into a crossover. Get one with enough outputs. For example, if you have two speakers in the cab and two subs then get one with 4 outputs. Hook the cab speakers to the high on the crossover, and the subs to the low outs on the crossover. The way crossovers work is the send everything over a certain frequency to the highs and the rest to the lows...you can change this frequency, of course. Good luck. BTW, I bought a cheap crossover and it worked fine.
|
Tyler
Dodge Dakota
JOIN HERE
11/24/2003
23:53:58
| RE: DVC Questions Please!!
IP: Logged
Message:
Thanks fellas! I found out today that the amp IS bridgeable, BUT the subs are 8 ohms and it won't brige to 2, 4, or 8 ohms. So I'm going to buy another box and one more sub and the 3 subs WILL bridge on the amp! Thanks a whole lot on the info!
Tyler
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
