Dodge Dakota ForumDodge Dakota PhotosDodgeDakota.net Membership
  Forums   Forum Tools
01:26:32 - 12/20/2024

General Dakota Board
FromMessage
Tom
Dodge Dakota
JOIN HERE
 Email

9/01/2003
11:56:08

Subject: KRC Timing Mod
IP: Logged

Message:
Wow, I checked the timing before and after the mod. 11 degrees before and 15 degrees after(initial timing). Keep in mind I have no aftermarket computer mods. Upon testing it, I floored it (((without powerbraking))) and the tires spun 10-15 ft. It has never done this before. It always hooked up and accelerated. At 60 mph it accelerates to 70 much faster and pulls harder on full throttle. This seems to be the BEST mod out there that didn't cost me a penny. It adds 4 degrees of timing across the board. All that was involved was taking off the crankshaft sensor, taking out the rubber grommet, elongating the bracket holes so you can slide the sensor ((far right as possible toward oil filter)) and tightening the bolts back down. DONE. It's amazing what this MOD did. It's probably comparable to a Hypertech Computer Chip if not more. It works on all 92 and newer Dakotas. Check out KRCperformance Timing Mods for more. Good luck and enjoy.




RT Mark
Dodge Dakota
JOIN HERE
 Email

9/01/2003
13:10:28

RE: KRC Timing Mod
IP: Logged

Message:
How do you access it?

From above under the aircleaner,
or from below behind the exhaust pipe?

Can I just drive up a curb, crawl under the car and get to it or do I need a lift or ramps?

If it's that easy, I wanna try it!



1Flamed92Dak
GenII
 User Profile


9/01/2003
14:29:07

RE: KRC Timing Mod
IP: Logged

Message:
I did that mod. All I got to say is WOW never knew what i was missing now she accelerates with a vengenance even in 100 degree weather and absolutely no pinging. I have done quite a few mods to my Dakota and all I got to say this one was by far the best one. Just got to remember to set it back when SMOG Inspections come around since they check timing now too.



TexasTodd
Dodge Dakota
JOIN HERE
 Email

9/01/2003
16:26:28

RE: KRC Timing Mod
IP: Logged

Message:
Tom,

Some people, (me), have a 4.7 motor. (Glad I do actually).

I checked it out and found this in their explanation.
"This will work on any Dodge truck 92- to present except for the 4.7L or the V-10."

By 'dealer' taking out 4 degrees, this sounds suspiciously like the 'death flash'. I don't have it on my 2001.



360dak
R/T
 Email User Profile


9/01/2003
20:19:04

RE: KRC Timing Mod
IP: Logged

Message:
didnt see that on krc anywhere.

'01 R/T Regular Cab, Intense Performance Air Intake, MSD6AL w/8.5mm wires, FlowMaster 40 series split dual, Autolite 3923's, 180° Thermostat, Brass contact distributor cap and rotor, IAT relocated, Mobil 1 Fully Synthetic Motor Oil.

360dak
R/T
 Email User Profile


9/01/2003
20:22:59

RE: KRC Timing Mod
IP: Logged

Message:
http://www.krcperformance.com/newcontent/timing.html

'01 R/T Regular Cab, Intense Performance Air Intake, MSD6AL w/8.5mm wires, FlowMaster 40 series split dual, Autolite 3923's, 180° Thermostat, Brass contact distributor cap and rotor, IAT relocated, Mobil 1 Fully Synthetic Motor Oil.

Timmy
Dodge Dakota
JOIN HERE


9/02/2003
04:45:34

RE: KRC Timing Mod
IP: Logged

Message:
Is KRC dead????



Every time I go there I get the page cannot be displayed blah blah blah.



   P 1


Post a reply to this message:

Username Registration: Optional
All visitors are allowed to post messages


Name:
Email:
Notify me when I get a reply to my message:Yes  No

Icons:            

          

Subject:
Message:
 



Home | Forums | Members | Pictures | Contact Us

This site is in no way affiliated with Chrysler or any of its subsidiaries.