Forums
Forum Tools
|
 |
03:54:00 - 12/24/2024
General Dakota Board
| From | Message |
Dakota_Duce
Dodge Dakota
JOIN HERE
8/20/2003
19:44:59
|
 Subject: Air Intake Question..
IP: Logged
Message:
Hi all..
The past few days I've read several web page articles on "home brew - self made" air induction systems for 2001 3.9 V/6 Daks. Seeing I wanted to save money and have a fun project to do, I purchased the same parts that were mentioned.
The problem I'm finding is the parts don't fit either the air hat.. or the APC air filter. As a example: both the male end of a three inch PVC 45* elbow (and a length of three inch PVC pipe) have three inch "inside" diameters. Because of the 1/4 inch thickness per case wall, the "outside" diameter of either piece is really 3 1/2 inches.. which will NOT fit into the three inch inside diameter opening of the APC filter (#15-1097). In addition: the three inch rubber Fernco 3x3 coupler (#P1056-33) has a "inside" diameter of 3 1/2 inches.. while the "outside" diameter of the air hat intake tube is three inches.
For those of you who have fabricated your own.. please explain how you were able to insert a 3 1/2 inch PVC piece into the three inch filter opening, while at the same time snugly fitting the 3 1/2 inch rubber coupler around the three inch diameter air hat intake tube. I tried several different ways and I couldn't get it done.
Thanks for your help...........
Dakota_Duce
Dakota_Duce@Yahoo.com
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
|
