Dodge Dakota ForumDodge Dakota PhotosDodgeDakota.net Membership
  Forums   Forum Tools
03:32:37 - 12/24/2024

General Dakota Board
FromMessage
jaggy
GenIII
 User Profile


7/30/2003
11:29:07

Subject: 360 Intakez feedback
IP: Logged

Message:
I just bought a 360 air intake and like it so far,
My issues are as follows.

It didn’t fit under the hood until I bent the brace for the fender down about 2 inches!

TB is quite a bit smaller than the intake tube and the rubber seals that are supplied had to be screwed down really far to create a seal.

With Heat shield attached there is no way to keep it off of my AC lines and it rattles whenever I get above 2500 rpm’s.

I am concerned that it may wear the lines form the constant contact.

The IAT had to be relocated (tube has a hole), or plug the hole. (no plug supplied.) I didn't ever think runs to the hardware store would be needed for this kit! (6pm sunday evening install....doh!)

I am content with the install but only marginally.
I would expect these issues from a home brew not a complete kit.
I did email these issues to 360 and they didn’t seem too concerned about it.

Does anyone else have feedback about this product?
Any feedback for me?
Thanks in advance.




   P 1


Post a reply to this message:

Username Registration: Optional
All visitors are allowed to post messages


Name:
Email:
Notify me when I get a reply to my message:Yes  No

Icons:            

          

Subject:
Message:
 



Home | Forums | Members | Pictures | Contact Us

This site is in no way affiliated with Chrysler or any of its subsidiaries.