| From | Message |
Galloway
Dodge Dakota
JOIN HERE
5/29/2003
17:44:32
|
 Subject: HO Cams and P0340 Code
IP: Logged
Message:
Just got done installing the HO cams and intake. Truck started right up and ran for a few miles then quit. Code shows up as 0340 - No Camshaft sensor signal - Anyone else seen this. Also, will just installing a new Cam sensor fix the problem or will it just run a couple of miles and quit again. Looking for help. Thanks.
|
mo-par
Dodge Dakota
JOIN HERE
5/29/2003
17:47:39
|  RE: HO Cams and P0340 Code
IP: Logged
Message:
try just unplugging it and plug it back in
also reset the pcm
|
Demon Dakota
DakotaEnthusiast
5/29/2003
18:58:44
|  RE: HO Cams and P0340 Code
IP: Logged
Message:
Well, there was no code on that sensor before the swap, so you either damaged the sensor, or maybe it wasn't functioning properly. Do what mo-par said...replug and reset your computer.
K&N Drop in AF (CAI during summer months)
True Dual exhaust and removed third cat
HO Cams & HO Intake
FASTMAN 70mm TB
Autolite 3923 Plugs
TPS @ .76 VDC
IAT Adjuster Mod
14.52@94.2 MPH at Silver Dollar Raceway
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
