| From | Message |
Matt
Dodge Dakota
JOIN HERE
5/14/2003
22:07:42
|
 Subject: Cam Problem
IP: Logged
Message:
We installed the HO cams in my 2001 4.7L, and when we were finished we fired it up and it sounded good so we cut it off to finish hooking up the air box. After we did this we started it and it ran for about 10 secs and just cut off. We checked fuses, fuel and everything looked good except it wasn't getting a spark from the plug. It cranks fine but just won't fire. If you can help me it will be appreciated thanks.
|
TexasTodd
Dodge Dakota
JOIN HERE
5/14/2003
22:20:35
|  RE: Cam Problem
IP: Logged
Message:
Sounds alot like the cam position sensor, on the front, bottom or the Passenger side cam, is at fault. That'd be my guess. Did you loosen it or anything?
|
Matt
Dodge Dakota
JOIN HERE
5/14/2003
22:25:01
| RE: Cam Problem
IP: Logged
Message:
Is that the one on the bottom of the head on the passenger side? Is it bad? What can I do to fix it?
|
SilverstoneV8
Dodge Dakota
JOIN HERE
5/15/2003
00:13:58
| RE: Cam Problem
IP: Logged
Message:
CAUTION: Do not hold or pry on the camshaft target wheel (Located on the right side camshaft sprocket) for any reason, Severe damage will occur to the target wheel resulting in a vehicle no start condition. .
Part of the cam install instructions...
Pull the valve cover and check it out...
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
