| From | Message |
BaDWoG
Dodge Dakota
JOIN HERE
1/16/2003
11:57:59
|
 Subject: CB Radio
IP: Logged
Message:
I Have Just Setup a UHF CB Radio in my Car.
The Radio is a Uniden UH-011 Radio
I have Mounted the Antenna in the Side of the Bonet When an old Antena For a CB Was before i owned the Car. i Led the Wire ip And through the FireWall And when i now listern to my CB i get Road Noises.
Please Help Also How should the But where the Antenna is Screwed in be Should there Be something be touching Ect!
|
wjco
Dodge Dakota
JOIN HERE
1/16/2003
17:10:20
|  RE: CB Radio
IP: Logged
Message:
Is the radio is hard wired in the truck or is it plugged in the cig lighter? If it's hard wired it is problably youtr ground wire or your antenna is not tightened down enough.
|
timberwolf
GenIII
1/17/2003
08:30:24
| RE: CB Radio
IP: Logged
Message:
Also, if you ran the antenna wire through the firewall, it must be running through the engine compartment. The antenna wire could be too close to a plug or coil wire and picking up noise that way.
|
BaDWoG
Dodge Dakota
JOIN HERE
1/19/2003
02:20:23
| RE: CB Radio
IP: Logged
Message:
Yehah i had it plugged in to the Ciggy Lighter Ill give that a go and then try some of the pther suloutions u gave me!
Does it Damage your Set if u have it plugged in to ther Ciggy Lighter and also is it good for the Base to be tuching the body of the CAR Not the Piece that Screws in the Aerial but a Little Below that a Big mettle Round Circle that goes around it .
|
ken
Dodge Dakota
JOIN HERE
1/19/2003
10:43:18
| RE: CB Radio
IP: Logged
Message:
No, it doesn't hurt the unit to plug it into the cig plug.
No, it doesn't hurt the unit of the metal antenna base touched the car body (though it'll sure mess up the paint).
You gotta keep the antenna cable OUTSIDE of the engine compartment.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
