| From | Message |
joe
Dodge Dakota
JOIN HERE
4/27/2004
15:15:23
|
 Subject: lower ball joint
IP: Logged
Message:
i have a 2000 dakota w/4WD. can i press the lower ball joint out while still on the truck?
|
um
Dodge Dakota
JOIN HERE
4/29/2004
22:44:43
| RE: lower ball joint
IP: Logged
Message:
you grind/torch the rivets off it holding it into the control arm, no press needed, yes you can do this on the truck
|
joe
Dodge Dakota
JOIN HERE
4/30/2004
06:00:20
| RE: lower ball joint
IP: Logged
Message:
um,
for the lower ball joints?
|
Jhb5221
Dodge Dakota
JOIN HERE
5/01/2004
09:09:14
| RE: lower ball joint
IP: Logged
Message:
I am doing my uppers and lowers, i have my truck
all lifted up and ready to take them off, but
I'm also not sure on how to do the lowers, Please send me an email ASAP. JHB5221@aol.com
|
Kev
Dodge Dakota
JOIN HERE
5/22/2004
12:25:59
| RE: lower ball joint
IP: Logged
Message:
Someone needs to read the topics more carefully...
Only the upper ball joints are rivetted on. The lowers are pressed and clipped.
I simply took my truck to Big-O tires and had them do it for me. They did the labor on my truck for $90 per side. The Moog ball joints cost me about $200 after shipping & handling. Throw in a front-end allignment for $50 and it comes out to a reasonable $430 to replace all the ball joints...and they will warranty their work.
Good luck!!!
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
