| From | Message |
yogi
Dodge Dakota
JOIN HERE
5/03/2004
20:18:46
|
 Subject: Amp kit size
IP: Logged
Message:
Hi i just bought an MTX thunder 4200x online. What amp kit
gauge should i USE.
thank you for your advice
RMS Power measured at 12.5 Volts DC:
25 Watts x 4 into a 4 Ohm load with less than 0.1% Thd+N
50 Watts x 4 into a 2 Ohm load with less than 0.3% Thd+N
100 Watts bridged x 2 into a 4 Ohm load with less than 0.3%
Thd+N
Dynamic Power (IHF-202 Std) measured at 14.4 Volts DC
55 Watts x 4 into a 4 Ohm load
100 Watts x 4 into a 2 Ohm load
200 Watts bridged x 2 into a 4 Ohm load
|
steveo27
Dodge Dakota
JOIN HERE
5/03/2004
22:03:47
|  RE: Amp kit size
IP: Logged
Message:
i would go with 4 gauge. look on onlinecarstereo.com, they have a few nice kits. i bought the absolute 900 kit, and i was very pleased with it.
-stevev
|
Justi
Dodge Dakota
JOIN HERE
5/03/2004
22:11:27
| RE: Amp kit size
IP: Logged
Message:
If that is the only thing you plan to run off of it you can use an 8ga or 10ga kit no problem, preferably the 8ga kit. Nothing wrong with the 4ga suggestion but it is not necessary for an amp that small.
Check eBay, you can get some decent prices on amplifier kits, just beware of the junk..
|
rhlam96
Dodge Dakota
JOIN HERE
5/04/2004
20:54:57
| RE: Amp kit size
IP: Logged
Message:
http://www.knukonceptz.com/
You can get a good deal on wires here.
|
SamWalton
Dodge Dakota
JOIN HERE
5/05/2004
01:01:06
| RE: Amp kit size
IP: Logged
Message:
Wal*Mart has amp install kits complete for about $20. Theyre good quality, what i always use unless i make my own.
|
Lurkin
Dodge Dakota
JOIN HERE
5/05/2004
10:20:44
| RE: Amp kit size
IP: Logged
Message:
As justi said, an 8-10 guage should work fine. Keep in mind though if you plan to do more upgrades later. If you add more wattage, then that 8-10 will need to be replaced.
If you think you'll do more upgrades, a 4 guage may reduce some later rework...
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
