| From | Message |
fourgivn1
Dodge Dakota
JOIN HERE
1/25/2002
12:28:07
|
 Subject: Thunderform install
IP: Logged
Message:
I just became the lucky owner of a $135 Thunderform enclosure for my new '02 Dak CC. Just curious as to how much work it is going to be to get that bad boy in there. I've basically heard that I push the seats all the way forward (the front seats that is), lift the back seats up, unbolt the old tray and wrestle it out, and then wrestle the new one in, keeping something 'slippery' like Pledge/Windex handy (to put on the sides so they 'slide' in easier), and bolt it in. Any suggestions/advice? Any at all would be appreciated.
|
R/Truck
Dodge Dakota
JOIN HERE
1/25/2002
12:33:08
|  RE: Thunderform install
IP: Logged
Message:
Not that easy
You have to remove the trim around the back walls, including seatbelts, upper and lower trim and seats. It can take several hours.
|
Bluethunder
Dodge Dakota
JOIN HERE
1/25/2002
16:22:59
| RE: Thunderform install
IP: Logged
Message:
I used a crowbar....no kidding...I got the first few bolts in but had to wedge the box back about 1/4" to line up the other holes....wasnt easy, but not too hard
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
