Dodge Dakota ForumDodge Dakota PhotosDodgeDakota.net Membership
  Forums   Forum Tools
03:46:44 - 12/24/2024

Custom Audio
FromMessage
PeteyDaMan
Dodge Dakota
JOIN HERE
 Email

6/27/2003
11:20:59

Subject: 01 wiring dagram
IP: Logged

Message:
You've all probaly seen this question a thousand times.
I'm looking to replace the amp in my 01 dak, with a crossover and 6 channel amp, new speakers, etc., but I want to keep the factory head unit.
question #1, does the hu put out high of low level to the factory amp?
Question #2, does anyone have the wiring diagram of the wires in and out of the factory amp. I can figure out most of them by what connects to the hu and what connects to the speakers, but there are a few extra's I have no Idea what they are for.

I called over to the dealer and they say they don't have any good digrams of it.

HELP!!!!



Jim Z
GenI
 User Profile


6/27/2003
18:28:11

RE: 01 wiring dagram
IP: Logged

Message:
" question #1, does the hu put out high of low level to the factory amp?"

High-level. amplified, roughly 7.5 volts RMS output.

"but there are a few extra's I have no Idea what they are for."

Well, the extras would be battery power, ground, and enable. I don't think there are any others connected.

Honestly, you're better off making a T-harness for behind the radio, and running new wires for the crossover. That'll save you a lot of trouble trying to decode the factory wiring, plus you won't have to cut off any connectors- making it easier to re-install the factory components should you decide to sell or trade the truck in later.



Jim Z
GenI
 User Profile


6/27/2003
18:30:59

RE: 01 wiring dagram
IP: Logged

Message:
oh, and one more thing about the head unit outputs. The head unit puts out a 7.5v RMS, _differential_ signal. Unless you have a crossover with high-level inputs (which I've never seen,) you _will_ need to use line-output convertors to convert the signal to ~2 volt RMS single-ended. running new wires will definitely be easier.



Petey Da Man
Dodge Dakota
JOIN HERE


6/29/2003
18:43:25

RE: 01 wiring dagram
IP: Logged

Message:
Thanks a bunch. I already have the line-output converters just didn't know if I was gonna need them. Good idea about running new wires from the hu to the new crossover. I don't really want to hack the factory plugs off.

Thanks again



   P 1


Post a reply to this message:

Username Registration: Optional
All visitors are allowed to post messages


Name:
Email:
Notify me when I get a reply to my message:Yes  No

Icons:            

          

Subject:
Message:
 



Home | Forums | Members | Pictures | Contact Us

This site is in no way affiliated with Chrysler or any of its subsidiaries.