| From | Message |
frederickz42
Dodge Dakota
JOIN HERE
3/15/2007
21:49:48
|
 Subject: 2 amps 2000 1000
IP: Logged
Message:
ok i have 2 amps a 1000 watt and a 2000 watt. and i also have 2 1500 Kicker L7's..and want to get an equal amount of power to both...how do i do it......but first off i need to be able to hook 2 amps up. i have all the wires ran and everything but im stuck right there can u help?
|
Alec
Dodge Dakota
JOIN HERE
3/18/2007
01:15:05
| 2 amps 2000 1000
IP: Logged
Message:
Be aware of Ohm's law and do not fry your amps....In other words, make sure the resistance of your subs are a perfect match for your amp.
Also, I believe that just that one 2000 watt (rms? probably not, most like 800-1000 rms) amp could push both subs with more power than you need.
|
TreyJones
Dodge Dakota
JOIN HERE
3/21/2007
23:12:45
| 2 amps 2000 1000
IP: Logged
Message:
I have a question, if i hook up 2 alpine MRV-T501(real old school) 300 watt RMS at 4 ohms stable amps, to one 4 ohm kicker compvx 12" sub, can i just run both amps to it on the exact same settings or will i have to buy one new amp.
How does Ohms Law work?
|
Alec
Dodge Dakota
JOIN HERE
3/22/2007
13:24:25
| 2 amps 2000 1000
IP: Logged
Message:
Ya I see what you're saying about combining the power from two different amps into one channel.....but ya I dunno, never seen it. I believe it would not be a wise choice, because if one amp was slighty out of phase with the other, youd kill the power output and clarity of the sub. (If it was completely out of phase, then you would get no sound at all! Ex: Sound cancellation technology).
Ohm's Law is V=I*R, which means the voltage is equal to Current times resistance. So when the resistance is lowered, and the Voltage is held constant, the current is increased. Too much current will fry your amp.
|
Shoe
GenIII
3/26/2007
21:01:15
| 2 amps 2000 1000
IP: Logged
Message:
Here is a great place to go to understand it.
http://www.galaxyaudio.com/OhmsLaw.html
'97 RC V6, 5spd, soon to be V8, 5spd!
|
Ryan
Dodge Dakota
JOIN HERE
10/26/2007
23:33:04
| Kicker
IP: Logged
Message:
i got two kicker 15inch cvr's. they are dual 2 dual voice coils. and i have a kenwood mono amp. how would you wire to get the most power out of the amp
|
daddio
Dodge Dakota
JOIN HERE
10/30/2007
16:09:46
| 2 amps 2000 1000
IP: Logged
Message:
i've got a site that might help you guys.
http://www.bcae1.com/
|
jonn1
Dodge Dakota
JOIN HERE
10/24/2010
16:48:48
| fiPcJUTCRTQZTJpq
IP: Logged
Message:
comment1,
|
| | <<Original Post <<Previous Page P 2 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
