| From | Message |
Nick
Dodge Dakota
JOIN HERE
1/17/2003
13:15:53
|
 Subject: amp wiring
IP: Logged
Message:
I just ordered a loaded T-form and some JBL components for the front. The amp I want to get is the Kicker KX800.4 It says it is 100 watts x 4 at 4 ohms, 200 x 4 at 2 ohms, and 400 watts x 2 bridged. Is that 4 or 2 ohms? Also,can I bridge the rear channels and still run the front two channels seperately, or do I need two seperate amps to run these speakers? Any advice is apreciated.
|
R/Truck
Dodge Dakota
JOIN HERE
1/17/2003
13:41:26
|  RE: amp wiring
IP: Logged
Message:
You can bridge two channels to run your subs, it will come out to 400 watts x 1 (4ohm mono load). So make sure your subs are wired to 4ohms, which a loaded T-form is. Then your front two speakers will get the other two channels. No problem.
|
nick
Dodge Dakota
JOIN HERE
1/17/2003
14:54:47
| RE: amp wiring
IP: Logged
Message:
Thanks man.
|
nick
Dodge Dakota
JOIN HERE
1/17/2003
14:59:39
| RE: amp wiring
IP: Logged
Message:
Hey, if I decide I'm not satisfied with the mtx subs, (I heard they aren't that great), How would I wire two dual voice coil subs in the T-form box to make a 4 ohm load? Also, do you think that 400 watts will be enough to push the mtx subs?
|
conig
Dodge Dakota
JOIN HERE
1/17/2003
17:34:17
| RE: amp wiring
IP: Logged
Message:
I have dual vc subs in my truck. you would wire them in series parralel.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
