| From | Message |
SquidLuv15
Dodge Dakota
JOIN HERE
8/17/2009
20:51:33
|
 Subject: 3.9L heads from a 95 onto a 2000??
IP: Logged
Message:
Just need to know if i can take the heads off of a 1995 3.9L v6 and put them on the 3.9 that is in my 2000???
|
?
Dodge Dakota
JOIN HERE
8/20/2009
13:24:14
|  RE: 3.9L heads from a 95 onto a 2000??
IP: Logged
Message:
Yes , but , Why ?
Are you re machining them first ?
|
J and J Auto
GenII
9/01/2009
03:18:06
| RE: 3.9L heads from a 95 onto a 2000??
IP: Logged
Message:
while you have the intake off take an old gasket
and bolt on with some bolts and washers and look
at the ports and you will see that part is not
machined out
hardware store get some sanding drums use a drill
and remove this material not just at the very end
but back into the port and you will gain 10hp
and 20 foot pounds of torque at the rear wheels with a gas mileage improvement around 1mpg
I have seen some with a overhang of a 1/4" plus
some were so bad the injector spray was hitting
and being forced back up the port
Larry
J&J Auto
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
