I have an '01 CC 4.7. I used 2 inch springs and blocks to lower my ride. (2inches all around - it's a Ground Force kit). The kit was fine,,but I need smooth it out, so I'm returning it to stock.
Do ya'll think if I put back the factory springs up front, and left the 2" blocks in the back that it would sit level? Seems like it would be almost dead on.. Just don't know.
Has anyone done this before?
Message: I haven't tried this but if you read some past threads there are mixed reviews. Some say that the back ends up 1/2" lower than the front and that you have to cut the block and some say that it is perfectly level. I would just try it and if it is to low in the rear make the required changes. I don't believe it is a hard change to make.
P 1
Post a reply to this message:
Username Registration: Optional All visitors are allowed to post messages
Subject: Will this sit level?