| From | Message |
John23454
Dodge Dakota
JOIN HERE
8/03/2003
17:54:24
|
 Subject: HO intake torque specs
IP: Logged
Message:
Does anyone know what the 4.7 HO intake torque specs are, how many inch pound or foot pounds to tighten them. Or does it even matter? Also the throttle body specs also. Thanks
|
jaggy
GenIII
8/04/2003
11:53:40
| RE: HO intake torque specs
IP: Logged
Message:
this is more of an asumption than a fact, just keep that in mind.
The cam install calls for 100 inch pounds because it is going into aluminum.
I would have to assume that to be the same for the intake manifold and TB.
Hopefully someone else will reply with facts.
|
Phil
Dodge Dakota
JOIN HERE
8/04/2003
15:35:39
| RE: HO intake torque specs
IP: Logged
Message:
25 ft/lbs for intake manifold
|
Demon Dakota
DakotaEnthusiast
8/04/2003
17:57:27
| RE: HO intake torque specs
IP: Logged
Message:
105 inch-pounds for the intake plenum.
K&N Drop in AF (CAI during summer months)
True Dual exhaust and removed third cat
HO Cams & HO Intake
FASTMAN 70mm TB
Autolite 3923 Plugs
TPS @ .76 VDC
IAT Adjuster Mod
14.52@94.2 MPH at Silver Dollar Raceway
|
John23454
Dodge Dakota
JOIN HERE
8/04/2003
19:19:00
| RE: HO intake torque specs
IP: Logged
Message:
Thanks guys, 105 inch pounds sounds right, anyone know about the throttle body? Demon Dakota, will the intake manifold wiggle out of the engine compartment without removing any accessories?
|
Demon Dakota
DakotaEnthusiast
8/04/2003
23:26:00
| RE: HO intake torque specs
IP: Logged
Message:
I suppose it can, but I took my entire top end apart when I did my swap, so...I'm not the best to ask. I was just bored one weekend and decided to take it all apart :)
K&N Drop in AF (CAI during summer months)
True Dual exhaust and removed third cat
HO Cams & HO Intake
FASTMAN 70mm TB
Autolite 3923 Plugs
TPS @ .76 VDC
IAT Adjuster Mod
14.52@94.2 MPH at Silver Dollar Raceway
|
TexasTodd
Dodge Dakota
JOIN HERE
8/06/2003
16:09:46
| RE: HO intake torque specs
IP: Logged
Message:
'yes it will!' says bob the builder.
Sorry, too many childens books.
I posted on this a few weeks ago.
DON'T follow the manual directions, they'll have you taking everything off!
LEAVE the fuel rails, a/c, alternator, etc.
Look for my post and read thru that, I did it right after I did my intake on my 4.7 to HO.
Good luck
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
