| From | Message |
cbsdakota
Unregistered
JOIN HERE
5/22/2001
16:10:23
|
 Subject: 3.9L JBA Header install?
IP: Logged
Message:
I was browsing around and went to Truck Performance to see how much a couple items were. There headers were way higher than anywhere else (the silver ceramic coated ones anyways). But, I read that the headers bolted right up to the stock Y pipe with basic tools. I popped my head under my truck and it looks fairly staight forward. Has anyone installed headers themselves and how was it? The only thing I can imagine being difficult is manuevering the manifolds out and the headers in. Some input would be great! Bernd: How much for these from you? All you post are the plain ones!
|
Dan Ingler
Unregistered
JOIN HERE
5/22/2001
16:29:50
|  RE: 3.9L JBA Header install?
IP: Logged
Message:
It was one of the easiest bolt-on's you can do. Simple hand tools and about an hour of your time. Too easy.
Dan
|
Bernd
Gen III
5/22/2001
16:34:33
| RE: 3.9L JBA Header install?
IP: Logged
Message:
Yup...installation is very easy. Ok...so we took about 2 hours with beer breaks. ;)
We'll be running a JBA Group Buy on the headers within the next week so hang tight...the prices will be very competetive.
1997 Dodge Dakota SLT - V6
Supercharged @ 10#
|
98SPRTV6
Unregistered
JOIN HERE
5/22/2001
17:53:43
| RE: 3.9L JBA Header install?
IP: Logged
Message:
check out the how-to section on my site, I have a write up on it in a PDF file.
The site is: http://come.to/98SPRTV6/
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
