| From | Message |
kowalski
Dodge Dakota
JOIN HERE
5/23/2003
19:04:39
|
 Subject: 4.7 HO cam tools
IP: Logged
Message:
A little slow but I'm finally ready to go the HO cam route. Any one have dimensions to make the chain wedge ? And how about the center spacing and diameter of the sprocket holes to make a tool to grab those ? I tried the search but didn't find the #'s easily, thanks in advance guys.
|
TexasTodd
Dodge Dakota
JOIN HERE
5/25/2003
07:08:26
|  RE: 4.7 HO cam tools
IP: Logged
Message:
kowalski,
I used to have pics, and the dimensions of the wedge that was made for my cam install. Sorry I can't seem to find them right now.
Basically it's about 5 inches long overall, 3/4 inch thick, and goes from about 1 inch, to 3 inches wide. You can buy the tool, or make it, (what we did), many have done it with no tool at all! A search thru the archives will bring alot of this up as well.
Good luck,
Todd Bouton
|
kowalski
Dodge Dakota
JOIN HERE
5/25/2003
10:33:11
|  RE: 4.7 HO cam tools
IP: Logged
Message:
Thanks, I'll make one out of hardwood before doing the job at a friend's shop soon, found pictures but no dimensions.
|
dennis
Dodge Dakota
JOIN HERE
1/31/2012
18:07:41
| ijIyMqHoXgHrcwToA
IP: Logged
Message:
<url>http://dennisssblegh.com|dennis</url>
hi
love your site!
|
dennis
Dodge Dakota
JOIN HERE
1/31/2012
18:19:47
| uBMYGbLBWxtB
IP: Logged
Message:
<url>http://dennisssblegh.com|dennis</url>
hi
love your site!
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
