Shawn
Gen III
 
5/19/2001
04:16:09
|
 Subject: NOS & Supercharger's
IP: Logged
Message:
Ok,
So I'm going to get this Powerdyne SC in and run it at 6PSI to get use to it, then move on to 9PSI. What I'm wondering is if I could toss in a little NOS to the mix? I don't have any internal engine work done, so yea I know about blowing the thing up, BUT:-) What about using a small 25hp - 50hp staged to phase out after 3000RPM's or so??? I would certainly get to good boost levels by then.
So I guess my question is what would yall recomend as a good low dose shot NOS setup that would work in this situation. How about running the low dose all the way through the boost, right up to the top? I am assuming I can retard the timing and get enough fuel to my baby, just wondering what I'll end up doing to her stock internals.
Would new heads with all the trimmings help with this or do I basically build a motor from scratch for this type of strain, pressure, and performance? I'd build a 360 to replace my 318 if thats the case.
Just feels like I could get away with a little shot of NOS.
Thanks for any help!
Shawn
98 5.2L 4x4 CC Sport
|
RE: NOS & Supercharger's