| From | Message |
TNRT
Dodge Dakota
JOIN HERE
3/30/2003
09:33:26
|
 Subject: 206X CAM
IP: Logged
Message:
RED97KOTA how has that KRC206X cam been working out???
|
RED97KOTA
Dodge Dakota
JOIN HERE
3/30/2003
21:51:23
| RE: 206X CAM
IP: Logged
Message:
It seems that the computer adjusts better every day, right now its in the body shop getting the shaker hood and Stillen cover painted. I really need the Hypertech programmer or a custom flash to get the rpm limit up as the motor is still pulling really hard at 4900. The motor runs like a banshee, totally different than it did with the r/t cam I had before. And the low end is as good as it was before as it still will lay good rubber from a standstill. I love the sound and the way it runs!!
|
Nick
Dodge Dakota
JOIN HERE
3/31/2003
06:24:26
| RE: 206X CAM
IP: Logged
Message:
I just installed the 210X on my 97 318. SOunds meaner then heck, I have yet to drive it due to salty and sandy roads locally, but I hope to get it out soon!
|
RED97KOTA
Dodge Dakota
JOIN HERE
3/31/2003
10:05:22
| RE: 206X CAM
IP: Logged
Message:
Yea, I love the sound of the 206X, with the 10 degrees more duration on the exhaust and 4 degrees more on the intake I'll bet the 210X really "cuts up" at idle. I was suprised though how well the 206X idled even with the a/c on after the pcm adjusted. Even though the idle is somewhat less than smooth it still is very acceptable. It's really great seing the shaker "quiver" a little!!
Nick,do you have a custom PCM or a stall converter??
|
TNRT
Dodge Dakota
JOIN HERE
3/31/2003
13:29:07
| RE: 206X CAM
IP: Logged
Message:
RED97KOTA Keep us updated on how it runs after you get flash or Hypertech. NICK What else are you running with your 210X and give us areport after you take it out.
|
Nick
Dodge Dakota
JOIN HERE
4/01/2003
18:22:23
| RE: 206X CAM
IP: Logged
Message:
Well my truck is a 5spd so obviously no stall. i have the mopar performance PCM and it handles the cam quite well. Idle is a bit rough at the moment but I am expecting it to smooth out a bit after the PCM learns. If not I am going to move the MAP vacum to the intake and see what that does. My current mods are 2.02 heads, M1, roller rockers, ported tb, headers with 3 inch exhaust, and double roller timing chain. I will let youall know how it runs when i get it out.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
