| From | Message |
Justin Whitt
DakotaEnthusiast
 
4/22/2001
14:11:06
|
 Subject: perfomance chips for the 4.7
IP: Logged
Message:
Hey
I have a 01 cc 4x4 4.7 5spd 3.92
dual cat-back no mufflers and a
Kenne Bell type cold air intake.
Which chip should I go with..
I want the most power I can get..
any suggestions help..thanks
|
RonW
*GenIII*
4/22/2001
16:10:53
| RE: perfomance chips for the 4.7
IP: Logged
Message:
You only have one choice, Jet Stage II.
Ron
00 PB SLT QC 4X2 5.9 46RE 3.92 LSD
|
Robert
Unregistered
4/24/2001
12:59:01
| RE: perfomance chips for the 4.7
IP: Logged
Message:
Where can I get a Jet Stage II? How much do they run?
Robert
|
RonW
*GenIII*
4/24/2001
13:03:57
| RE: perfomance chips for the 4.7
IP: Logged
Message:
www.truckperformance.com
Ron
00 PB SLT QC 4X2 5.9 46RE 3.92 LSD
|
Jonas Janek
Unregistered
4/24/2001
13:15:20
| RE: perfomance chips for the 4.7
IP: Logged
Message:
I have heard that the Jet stage II's are no good on the 4.7's anyone have one?
Jonas
|
RonW
*GenIII*
4/24/2001
13:34:46
| RE: perfomance chips for the 4.7
IP: Logged
Message:
They work for some and not for others. I've heard some 4.7 owners say they don't do bad. That also goes for a few 5.2 owners and a few 3.9 owners. The only ones they don't do a thing for are us 5.9 owners.
Ron
00 PB SLT QC 4X2 5.9 46RE 3.92 LSD
|
MACE
Unregistered
4/24/2001
14:16:55
| RE: perfomance chips for the 4.7
IP: Logged
Message:
Hypertech: http://www.hypertech-inc.com/ will have a Power Programmer III for the 2001 4.7, due out in the summer. It reprograms your stock PCM, it is not a chip or PCM you swap in. Also allows you to restore factory specs to the PCM if you feel the need to do this, when bringing your truck in for service.
Here are some of the parms you can tweak for:
Top Speed Limiter
Transmission Shift Firmness
Transmission Shift Points
Engine Rev Limiter
Cooling Fan "On/Off" Temperature
Speedometer/Odometer Corrections for
Non-stock Tire Sizes and/or Gear Ratios
|
Patrick ODay
GenI
4/24/2001
14:23:55
| NW Dakota Owners Meet
IP: Logged
Message:
There will be a meeting of the Oregon & SW Washington Dakota USA club on May 16 in Portland Oregon. All Dakota owners and DML members are invited to attend. This will be the first meeting of our chapter. We will be deciding as a group how we want to structure our club and what activities we would like to participate in.
The meeting will be held at the Timberline Dodge conference room at 2510 NE Sandy Boulevard Portland OR 97232. (503) 234-0771 or (800) 888-6241.
For more information email me at ordakotusa@home.com
Or email the President of Dakota USA at chris@dakotausa.com
Please feel free to visit us at www.dakotausa.com
Patrick ODay
Dakota USA NW Chapter
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
